strojeni

**Trimming of the sail:**
1. Put the mast in the mast sleeve of the sail (above cambers, not inti cambers) and extension adjusted for the right lenth put into the mast. Check if the mast top is laid right way in the strap of the top part of the mast sleeve. 2. Put the trimming line (not thicker than 4 mm) through sail rolles and mast adapter, so that it is not crossed and trim the down haul 10 - 20cm before maximum trimming. * 3. Fix the boom to the mast and trim the sail in the boom for the maximum quoted on the sail. *4.Set the cambers on the mast - do not close the covers.** 5. Trim the bottom of the sail to the rolles. (Now close the cover on the mast sleeve). If it is not possible - shorten the cambers. 6. If the wrinkles on the sail are transverse to the batten pockets, it is necessary to tighten the battens with the screwdriver.** (*Pay attention! The sails are made for the carbon masts by TECHNOFIBER. For those the length of cambers is adjusted. If you use different one, it means thicker one the cambers are too long and they will not switch. Therefore shorten the cambers by 3mm and more - see the picture.) Put apart the sail in oposite way from the completing - do not loose the battens! Pack the sail and put in the sailbag always the same way as originally. How take care of the sail. Never expose the sail to the sunshine - it makes the sail materials fragile. Never trim the sail on the concrete or sand. It can cut the stitches and scratch the monofilm. After sailing wash the sail, do not use salty water. You can eventually use a soap. RECOMMENDED MAST: Technofiber	*- not concerning sails without cambers